News

Quadcept 9.0.3 released

Added New Function

Circuit Designer

  • Substantially improved the Altium/Protel conversion function(Protel DXP or above now supported).

PCB Designer

  • Added a feature to convert PCB data from other CAD systems(The import of a PollEx ASCII file is now supported).
  • Changed the number of digits of measure.
  • Floating vias and stub vias are now detected by DRC.

*Altium and Protel are registered trademarks or trademarks of Altium Limited.

*PollEx is registered trademarks or trademarks of ©POLLIWOG Corporation.

Fixed Issue

Common

  • Enhanced reliability for the processing of writing data to a file by rotating data.
  • Improved the processing of locking when reading / writing data to a file.
  • Fixed an issue that caused an error when saving a file under a certain situation.
  • Fixed an issue where a big arc was rendered off alignment(Circuit, PCB, Gerber).

Circuit Designer

  •  Improved performance when wiring.
  • Improved performance when moving objects including wires using Relative Move.
  • Fixed an issue where the pin point of a wire did not disappear when using Connection Point.

PCB Designer

  • Abolished automatic deletion function for floating vias.
  • Fixed an issue with the performance when selecting planes / filled objects.
  • Fixed an issue where an Assembly Area was generated on incorrect coordinates in certain data.
  • Fixed an issue that caused an error when routing with Stop at First Obstacle enabled.
  • Fixed an issue that caused an edited component check error when hiding silks and performing DRC.
  • Fixed an issue that caused an error when performing DRC in certain data.
  • Fixed an issue where some settings became improper when importing DRC/MRC settings.
  • Fixed an issue with the performance of Select Attribute.
  • Fixed an issue where a line with the width of “0″ was not the measurement target of the measuring function.
  • Fixed an issue that output improper gerber data when editing the radius of a circle polygon and circle cutout.
  • Fixed an issue where a Keep Out Area was not correctly updated when updating components.
  • Fixed an issue that displayed an improper message when updating components.
  • Fixed an issue that caused an error when placing a specific footprint.
  • Fixed an issue where the Toggle Outline View (Plane) button did not work.

Design Converter

  • Fixed an issue where a rectangular pad created using lines was converted into an oval pad.
page top button